2020 Ford Explorer Brake Pad Replacement Cost in Tampa, FL

Brake pads press against the rotors when you apply the brake pedal. The friction slows your car and over time the pad material wears down. On a Explorer, front pads do roughly 70 percent of the braking work and wear faster than the rear pads. Most owners replace the front pads first, with the rear pads following 10,000 to 20,000 miles later.

The job involves removing the wheel, unbolting the caliper, sliding out the old pads, compressing the caliper piston, and installing new pads with fresh hardware. A shop typically allots 1.5 to 2.5 hours of labor time per axle. Adding rotor resurfacing or replacement bumps the job to 2.5 to 4 hours depending on the rotor condition.

Explorer ST uses the 3.0L EcoBoost V6 and has larger front rotors and upgraded brakes vs base. Platinum also uses the 3.0L with similar brake hardware. XLT, Limited, and Timberline with 2.3L share standard brake specs. Confirm trim and engine family before ordering. The rotors usually last through two pad replacements before they need machining or replacement, which is what causes the cost spread you see between shops.

Most Explorer owners get 30,000 to 70,000 miles from a set of front brake pads under normal driving. Highway commuters reach the higher end. Stop-and-go city traffic lands closer to 30,000. Tampa, FL driving puts more wear on brakes than long-haul interstate driving, so plan for the lower end of that range if your daily commute runs through downtown traffic.

Four warning signs mean it is time to inspect the pads:

• Squealing or chirping when braking. The wear indicator is contacting the rotor.
• Grinding metal sound. The pad material is gone and the metal backing is grinding the rotor surface, which damages the rotor and adds cost.
• Soft or spongy pedal. Often means low pad material or air in the brake lines.
• Vibration through the steering wheel under braking. Usually warped rotors from heat buildup with worn pads.

Front and rear pads wear at different rates. Front pads usually last 30,000 to 50,000 miles. Rear pads last 40,000 to 70,000 miles. Some owners replace pads in pairs by axle to keep braking balanced, others replace all four together. Either approach works. Rotors typically survive two pad replacements before they need to be resurfaced or replaced.

Brake pad replacement is one of the more approachable DIY jobs on a Explorer. Aftermarket ceramic pads run roughly $50.00 to $115.00 for the front axle from major retailers, including a hardware kit. That covers the full parts cost if you handle the work yourself.

The same job at a Tampa, FL shop runs roughly $186.00 to $365.00 based on real quotes. The labor portion is $156.00 to $260.00 for 1.2 to 2.0 hours of work at typical Tampa, FL shop rates.

Three reasons most Ford owners use a shop. Brake hardware needs torquing to manufacturer specs, which requires a torque wrench. The shop disposes of the old pads and any contaminated brake fluid. The shop typically offers a 12-month or 12,000-mile warranty on parts and labor, so if something goes wrong you have recourse.

If you do the job yourself, plan two to four hours per axle. You need a floor jack, jack stands, a torque wrench, a brake caliper compression tool, and basic hand tools. The procedure is well documented for the 2020 Ford Explorer in the owner manual.